C Variety Flex-Flex Couplings
The C Sort coupling includes two flex hubs, a single sleeve and 1 accessory kit consisting of seals and snap rings.
CFR Form Flex-Rigid Couplings
The CFR Style coupling include a single flex hub, 1 rigid hub, one sleeve, a single accessory kit consisting of seals and snap rings.
Options
Easy and low-cost type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Accessible as vertical and horizontal couplings
Wide assortment of specific variations including full-flex, flex-rigid mill motor
Normal configurations can be found with the shelf
Ordering Information
Application: Driver and Driven.
Variety and size of coupling, horizontal, vertical etc.
Power: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Type Couplings
Ordering Information
Puller Holes are regular on sizes 4 via twelve.
Puller Holes are available for sizes 7/8 by way of three.5 at an additional charge.
The BSE (distance Between Shaft Ends) may possibly fluctuate involving G and G1.
Interference bores without set screws are conventional unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Area.
Larger sizes are available, please seek the advice of Technical Help.