Power UNITS FOR LIFT TABLE 1
General Description
This power unit is created solely for the little lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is widely applied from the market of logistic devices for example minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is managed through the solenoid valve using the pace controlled by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This energy unit is built solely for the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and also the pace managed through the adjustable needle valve. Once the lift rises to a substantial positoin, however the electrical power supply is reduce, the reducing motion is managed by the guide override function.
Electrical power UNITS FOR LIFT TABLE 3
Basic Description
This electrical power unit is designed exclusively for the substantial lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve as well as the speed controlled by a pressure compensated movement control valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This energy unit is built solely for the significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve along with the velocity controlled through the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is cut, the reducing motion is controlled from the manual override function.
Distinctive Notes
one. This energy unit is of S3 duty cycle, which might only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic components concerned prior to installation of the energy unit.
3. Viscosity with the oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is advised.
four. Oil modifying is required right after the first 100 operation hours,afterwards as soon as every 3000 hrs.
five. The electrical power unit proven is designed to be mounted vertically.