SL cross slider coupling

SL Oldham Slider Couplings Oldham Slider Couplings are also known as metal slider couplings. The sliders are ring-shaped and made of steel or wear-resistant alloys. They are suitable for low speed and large transmission torque. Transmission

SL cross slide coupling (Q/JL03-2001)

The material of the Oldham coupling parts can be 45 steel, and the working surface needs to be heat treated to increase its hardness; Q275 steel can also be used when the requirements are lower, without heat treatment.In order to reduce friction and wear, oil should be injected from the oil hole of the middle plate for lubrication during use.Oldham slider coupling is also known as metal slider coupling. Its slider is in the shape of a circular ring and is made of steel or wear-resistant alloy. It is suitable for transmissions with low speed and large transmission torque.The Oldham coupling is composed of two half couplings with grooves on the end faces and a middle disc with convex teeth on both sides.Because the convex teeth can slide in the groove, the relative displacement between the two shafts during installation and operation can be compensated.Because the half-coupling and the intermediate disc form a moving pair and cannot rotate relative to each other, the angular velocity of the driving shaft and the driven shaft should be equal.However, when working with relative displacement between the two shafts, the middle disk will generate a large centrifugal force, which will increase the dynamic load and wear.Therefore, pay attention to the working speed not greater than the specified value when selecting.This kind of coupling is generally used at a rotation speed n<250r/min, where the shaft stiffness is relatively large and there is no severe impact.