• | Information Center
  • XINLAN coupling > information centre >
  • 　The correct choice of high-speed diaphragm coupling
  • The high-speed diaphragm coupling is composed of at least one diaphragm and two shaft sleeves.The diaphragm is fastened to the shaft sleeve with a pin and generally does not loosen or cause backlash between the diaphragm and the shaft sleeve. ...
  • 　Installation and precautions of pump coupling
  • The installation process of the coupling is not complicated, but the quality of the installation is critical. Improper operation can cause machine vibration, excessive bearing wear, and mechanical seal failure. ...
  • 　The reason why the inner and outer gear rings of the coupling cannot be meshed normally
  • If a large error occurs in the gear coupling during the production process, the inner gear ring and the outer gear ring cannot mesh normally. This is also because the two shafts are not on the same horizontal line...
  • 　Calculation of Torque of Slurry Pump Coupling
  • The power of the power machine in the transmission system should be greater than the power required by the work machine. ...
  • 　Introduction to XINLAN's Analysis of the Dynamics of Universal Couplings
  • When choosing a universal coupling, you should consider the various factors mentioned above in accordance with the actual conditions and requirements of the users, and select the best coupling varieties, types and specifications that suit your needs from the existing standard couplings. ...
  • 　Flange coupling is installed by means of half coupling
  • When the flange coupling is installed, it is centered by means of the convex shoulder on the half coupling and the groove or the split ring; when working, the torque is transmitted by the friction between the contact surfaces of the two half shafts or the bolt shear. ...
  • Home
  • Previous
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • N
  • last page
  • Total 72page427Article
  • Industry Information
  • Technical Information